Welcome, Guest. Please login or register.
Did you miss your activation email?

Username: Password:

Author Topic: Solenoid controlled damper for the blower  (Read 7662 times)

Leever2000

  • Training Wheels
  • *
  • Offline Offline
  • Posts: 19
  • OWF Brand: Mahoning
  • OWF Model: 200
    • View Profile
Solenoid controlled damper for the blower
« on: October 04, 2018, 06:30:13 AM »

My blower failed and have a new replacement Dayton Blower but do not have a damper. My options are to grind off the old damper and have it welded on to new blower. Are the other non welding options?  See typical blower with damper for Mahoning OWF
Logged

mlappin

  • Fabricator Extraordinaire
  • Global Moderator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4140
  • OWF Brand: homebuilt, now HeatmasterSS
  • OWF Model: Martin Steel Works Gen 1 then, now a G200.
  • North Liberty, Indiana
    • View Profile
    • Altheatsolutions
Re: Solenoid controlled damper for the blower
« Reply #1 on: October 04, 2018, 07:10:12 PM »

If you can’t weld it your self is there enough room internally to use pop rivets?
Logged
Stihl 023
Stihl 362
Stihl 460
Sachs Dolmar 112 and 120
Homemade skid steer mounted splitter, 30" throat, 5" cylinder
Wood-Eze model 8100 firewood processor

HeatmasterSS dealer for Northern Indiana

E Yoder

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1296
  • OWF Brand: HeatMaster
  • OWF Model: GS 100
    • View Profile
    • www.heatmasterfurnace.com
Re: Solenoid controlled damper for the blower
« Reply #2 on: October 05, 2018, 02:52:31 AM »

Or even self tapping screws if you're careful to miss the fan wheel.
Logged
HeatMaster dealer serving southwest VA.
www.heatmasterfurnace.com

Leever2000

  • Training Wheels
  • *
  • Offline Offline
  • Posts: 19
  • OWF Brand: Mahoning
  • OWF Model: 200
    • View Profile
Re: Solenoid controlled damper for the blower
« Reply #3 on: October 30, 2018, 09:26:26 AM »

I had a local welder do the work for $10 and blower working well. Both of doors (firebox & ash) doors are not closing correctly (light at the corners and asked the welder what could be done. He mentioned he has a press, have any of you had doors do this and what did you do? I'm thinking it would be worth a try just because new doors are a little expensive.
Logged