Welcome, Guest. Please login or register.
Did you miss your activation email?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Shaver Furnace / Will Shaver be around after EPA Regs change
« on: February 15, 2015, 09:37:37 AM »
Does anybody know if Shaver will survive the new EPA Regulations on OWB? If they don't then what happens to the warranty?
2
Shaver Furnace / Water Usage
« on: November 30, 2014, 03:13:24 PM »
I have a model 165 and I have been turning on the file value each time I add wood. I leave it on until it over flows. When I am adding wood the temp is usually about 158 to 165. The max temp is usually 175 but would be higher if outside temp is higher so not as much demand for heat. I feel like I am added to much water and am watering down the chemicals. I test with a test kit and am adding boiler solution as needed. I have had only one boil over due the warm weather and wind blowing.
My question is should I be adding water when the temp is higher because of the thermal expansion of water as it is heated. I would like to come up with some method of capturing the excess water from the over flow and return it to the boiler when the temp is lower.
My question is should I be adding water when the temp is higher because of the thermal expansion of water as it is heated. I would like to come up with some method of capturing the excess water from the over flow and return it to the boiler when the temp is lower.
Pages: [1]