Welcome, Guest. Please login or register.
Did you miss your activation email?

Username: Password:

Author Topic: Replacing nossel  (Read 2409 times)

randy_1

  • Full Member
  • ***
  • Offline Offline
  • Posts: 162
  • OWF Brand: Portage & Main
  • OWF Model: Optimizer 250
    • View Profile
Replacing nossel
« on: August 29, 2016, 07:14:09 PM »
Any one had a hard time getting the old nossel out of the 250,? I've tried a small automotive screw jack but it seems to be taking a lot more pressure than I am comfortable with. I don't want to ruin the base it sits in. Any thoughts?
Logged
Kubota L 3300

coolidge

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1409
    • View Profile
Re: Replacing nossel
« Reply #1 on: August 30, 2016, 03:46:38 AM »
You may have too persuade it a little, might even come out in pieces.
Logged
Western Maine

Cabo

  • Full Member
  • ***
  • Offline Offline
  • Posts: 149
  • OWF Brand: P & M
  • OWF Model: Optimizer 250
    • View Profile
Re: Replacing nossel
« Reply #2 on: August 30, 2016, 02:40:47 PM »
I used an air chisel.  It took about 10 minutes to get it out, clean up and drop the new one in.
Logged

randy_1

  • Full Member
  • ***
  • Offline Offline
  • Posts: 162
  • OWF Brand: Portage & Main
  • OWF Model: Optimizer 250
    • View Profile
Re: Replacing nossel
« Reply #3 on: October 23, 2016, 05:42:35 PM »
Yup ,,,hammer and a chisel and it was done in a short time  >:D
Logged
Kubota L 3300