Welcome, Guest. Please login or register.
Did you miss your activation email?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
HeatMaster / G400 Metal deterioration
« on: December 28, 2019, 06:11:50 AM »
This is what our furnace looked like after one year of burning. I am posting on here to start a thread and see if any others have had this issue. I have been in contact with the factory and finally got an answer with a letter dated from over a year ago. Not Good. Please let me know if anyone has seen this. Also in the letter I was informed it was from burning the stove too hot. Impossible as the deteriorated area is under ash in the firebox. Frustration maxed out now.
2
Advanced Plumbing / Manifold Design for a G400
« on: September 19, 2016, 11:43:59 AM »
I am looking into installing a Heatmaster G400 boiler in a location where we had prior outdoor boilers. The Shop is a on demand loop and the house is a consistenly running loop. We need this manifold to help with efficency and provide the boiler flow requirement. I am looking for a neat proffesional design to go along with everything else we have done. I am not against manufactureing one out of steel or plumbing one in with iron pipe. I do know the boiler requires a minimum pipe sizing of at least 1 1/2". Thus making this manifold a good size unit. Any pictures or design ideas any one has would be greatly appreciatted.
Pages: [1]