I'm installing a new heatmaster. I added a kickspace heater in my bedroom as it is sometimes cooler in that room. It uses 1/2" line. I have a single loop running to my sidearm, then going to my water to air in my furnace, then before the line loops back outside to the furnace I have a 1"X1"x1/2" tee then 14inchs down the line is a Venturi Tee where the return from the kickspace heater goes back into. This is plumbed the way the kickspace heater instructions stated. Will I be able to get all the air out of the lines? The instructions showed having a air bleeder before and after the heater but the Heatmaster is not a pressurized system so I hoped all the air would work itself out. Am I living a dream or will it work.