Didn't skip any Insulation. Radiant pump runs 75 percent.
Wish I had that data logger today, 200 ran from 830 this morning until 230 this afternoon to bring the water too 180.
HUH? Seriously something is very wrong somewhere.
I restarted my G200 last night, water was like 72 degrees. Did a charcoal trick, in five minutes was running pretty strong, so lets say from 8pm till a little before midnight it ran, in that time it brought the 200 gallons in the stove up to temp plus the 450 gallons in the shop.
Do you have temp gauges on the supply and return at the stove? If so what are the temps? if it’s obvious the garage is sucking all the heat, whats the actual temp of the supply when it gets there compared to when it leaves the stove?
I didn’t even have to go into my shop to tell when the waste oil boiler to FPHX pump kicked in, one time I checked and the supply and return were as close as possible with the inherent accuracy of the gauges, next time I checked supply was 142 while return was about 98.