This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Hardy / does hardy buy back there wood stoves

« on: January 24, 2013, 09:43:21 PM »

I had a guy tell me hardy will buy back there wood stoves from u has anybody heard of this mine has crack he said they wood buy it back and fix it and sell it for reconditioned one anyone know

2

Shaver Furnace / stove rusted out around pipe and inspection plate

« on: January 16, 2013, 03:44:04 PM »

My stove is 4 years old noticed i was using olot of water out of stove thought i had a leak could not find one so i took insulation of the top to look inside the water jacket threw the inspection plate and all around the pipe and half the the plate was rusted out the pipe the only part holding the pipe is where it is welded going threw the water tank into thebarrel where the wood goes i dont know why it did it i keep the pipe caulked around pipe and made a flanch that covers the pipe so water dont come in there any ideas no water leaks yet but would this cause me to lose alot of water by steam coming out of that big area dont make since this isnt even in the water and the insection plate was sealed with caulk just going on fourth winter of burn. shaver did say take some pics send them and they would replace stove just need pics for proof said just for record so see what happens. any info on this anyone

3

Shaver Furnace / what is the best temp to set your stove at what about dif temp

« on: October 11, 2010, 08:53:17 PM »

I got mine set blower kick on 157 off at 165 8 deg dif I replaced my old thermostat with a ranco 111000 love it the temp is right on. works great its a must. big difference in controlling temps. is this a good setting. thanks for any info

4

Shaver Furnace / replacing the caulk on the door shaver165

« on: October 01, 2010, 09:37:20 PM »

Has anyone replaced the caulk on the door yet if so what kind of caulk is best to use and how did you go about doing it noticed mine is leaking any good thoughts on this. Is it best to shout the door all the way after caulking it or leave it open just a little. thanks for any help.   

5

Shaver Furnace / how to wire a ranco 111000 temperature control on shaver 165

« on: September 29, 2010, 06:11:20 PM »

Can anyone help me on how to wire this thermostat up what diagram to use in the instruction that come with it i think maybe figure 4 but not sure. or maybe someone can draw one and explain in it how to hook it up. any help wanting to fire the stove up need to wire it up firt thanks  on a shaver 165

6

Shaver Furnace / remote bulb thermostat

« on: September 15, 2010, 06:37:07 PM »

What is a good thermostat to replace the old one and where is the best place to put it i thought in the line below the pump then you would get the water temp coming out of the stove good or not thanks for any help

7

Shaver Furnace / water pump on stove

« on: September 15, 2010, 06:27:13 PM »

Is it better to have your water pump run all the time or cycle on and off with the thermostat. And do you think you would burn more wood with the pump running all the time.