Welcome, Guest. Please login or register.
Did you miss your activation email?

Username: Password:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - E Yoder

Pages: 1 [2] 3 4 ... 87
16
General Discussion / Re: Merry Christmas!
« on: December 26, 2020, 03:55:06 PM »
Yes, snow was squeaky this morning. Love it.

17
General Discussion / Re: Creosote Cleaners Any Good?
« on: December 26, 2020, 03:53:46 PM »
Boxes would help. Just long burn times too.

18
General Discussion / Re: Coldest Weather Of The Season On The Way
« on: December 25, 2020, 08:07:35 AM »
Good to see you wreckit. Stay warm.

19
Central Boiler / Re: Merry Christmas!
« on: December 24, 2020, 03:32:21 PM »
Same to you Roger!

20
General DIY remodeling without Hydronics / Re: AC2 treated lumber
« on: December 22, 2020, 03:37:27 AM »
 :thumbup:

21
General Discussion / Re: Merry Christmas!
« on: December 19, 2020, 03:37:11 AM »
Merry Christmas to you.  May the weather be frightful but your fire delightful.
(Lol)

22
I've never heard of that one.

23
HeatMaster / Re: G400 Metal deterioration
« on: December 07, 2020, 03:02:00 AM »
Good to hear!

24
HeatMaster / Re: Air Flow Issue
« on: December 01, 2020, 02:56:15 AM »
Yup, that's an easy one to miss. I've had guys go over the whole stove with no improvement, but miss the chunk of ash on top of the fan that was the whole problem.

25
HeatMaster / Re: Air Flow Issue
« on: November 30, 2020, 03:21:41 AM »
Agree with RSI, also make sure there's no ash packed over the nozzle, or ash piled up behind the lower horseshoe brick under the tubes.
Follow the airflow from damper inlet disc to chimney through the whole unit and you'll find it.

26
I would agree, seeing them in person is important, all three have improved greatly over the last 5-10 years.

27
That video had several inaccuracies.
I've pulled at turb out the top exactly one time, and that was due to my ignorance, I could had freed it up in place. The guy had packed the whole back end of the stove with ash.
No matter what the brand, I'd cruise the forums, FB groups. Look at general feedback.

28
Plumbing / Re: No hot water to the heat exchanger
« on: November 19, 2020, 03:19:54 AM »
Air is a funny thing, I've learned to "power purge" by the school of hard knocks.  :)

29
Plumbing / Re: No hot water to the heat exchanger
« on: November 18, 2020, 02:28:16 AM »
 I was thinking the same thing, maybe some blockage reducing the flow so low it can't pick up air and push it out of the coils. I'd put a hose bib in the loop and purge both ways.

30
I agree with Marty, if there's creosote on the turbulators you've got a major burn issue. I tried burning some big wet blocks this summer, my turbs got tight. Switched to smaller dryer pieces, the issue disappeared in days. I'm loving my new G7000.

Pages: 1 [2] 3 4 ... 87