Welcome, Guest. Please login or register.
Did you miss your activation email?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
General Outdoor Furnace Discussion / Husqvarna 455 rancher for$199 @ Sears
« on: May 26, 2013, 07:40:43 AM »
I just bought a Husqvarna 455 rancher for $199 at Sears.
I was in the store to pick up a 240 for $109 but when I seen the 455 I had to have it instead!
Here is the link to it online:
http://www.sears.com/husqvarna-455-rancher-55.5cc-3.5hp-20inch-chain-saw/p-07135269000P?prdNo=1&blockNo=1&blockType=G1
Good luck!
Probably the wrong forum but this one gets the most traffic!
I was in the store to pick up a 240 for $109 but when I seen the 455 I had to have it instead!
Here is the link to it online:
http://www.sears.com/husqvarna-455-rancher-55.5cc-3.5hp-20inch-chain-saw/p-07135269000P?prdNo=1&blockNo=1&blockType=G1
Good luck!
Probably the wrong forum but this one gets the most traffic!
2
Equipment / Husqvarna accessories 1/2 off @ Tractor Supply today only!
« on: April 28, 2013, 01:52:54 PM »
Husqvarna accessories 1/2 off @ Tractor Supply today only!
I just picked up a set of chaps for $32 big jug of bar oil for $6 and some mix for $1.50.
I would have bought more but selection was limited. Monday they are going to start carrying Jonsered.
I just picked up a set of chaps for $32 big jug of bar oil for $6 and some mix for $1.50.
I would have bought more but selection was limited. Monday they are going to start carrying Jonsered.
3
Portage & Main / Steve in OHIO install ML36
« on: November 09, 2012, 10:19:30 PM »
Thought I might share my OWB install.
I bought a 2009 never fired ML36 from Rory at Portage and Main, it had been sitting in Erie Pa. for the last few years.
I started prepping my site back in august by scrapping all the topsoil at the edge of my driveway and digging the trench to where the ML36 will sit. 35 ton of asphalt grindings later my site was level with my drive so all I had to do is walk out my garage and fill the stove.
Logstor going into the basement.
Finished grade and waiting for concrete pad 11'6'' x 22' with a 11'6'' x 32 woodshed on top of it. 9' has a half roof by the stove.
Present with the woodshed and boiler sitting on pad.
My present day money magnet, oil boiler going thru 900 gallons a year!
Has a boilermate for the hot water.
Still scratching my head with the final plumbing. Ran some struts to hang the copper pipe and HX
Logstor to copper pipe to 50 plate heat exchanger.
I bought a 2009 never fired ML36 from Rory at Portage and Main, it had been sitting in Erie Pa. for the last few years.
I started prepping my site back in august by scrapping all the topsoil at the edge of my driveway and digging the trench to where the ML36 will sit. 35 ton of asphalt grindings later my site was level with my drive so all I had to do is walk out my garage and fill the stove.
Logstor going into the basement.
Finished grade and waiting for concrete pad 11'6'' x 22' with a 11'6'' x 32 woodshed on top of it. 9' has a half roof by the stove.
Present with the woodshed and boiler sitting on pad.
My present day money magnet, oil boiler going thru 900 gallons a year!
Has a boilermate for the hot water.
Still scratching my head with the final plumbing. Ran some struts to hang the copper pipe and HX
Logstor to copper pipe to 50 plate heat exchanger.
Pages: [1]