This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

361

General Outdoor Furnace Discussion / Re: New Forum Layout

« on: May 10, 2015, 05:48:23 AM »

Empyre should be in the EPA certified category.

Isn't Empyre Pro- Fab?

362

Heatmor / Re: Heatmor 200ss dropin at year 19

« on: May 05, 2015, 06:17:32 PM »

I am no pro so someone else can give you better advice, but last I used was 308L trimix gas(90%heilum, 7.5%argon, 2.5%carbon dioxide). Never worried about preheating etc. But again I'm not a pro.

363

Heatmor / Re: Heatmor 200ss dropin at year 19

« on: May 04, 2015, 06:12:20 PM »

I have never done a Heatmor but Global Hydronic  were bad for cracking welds. Get it clean and I use a wire welder. Yes you need a plasma cutter to get inside tank or install a new piece. Sounds like you should be able to get it from inside the firebox.

364

General Outdoor Furnace Discussion / Re: Shut down the boiler =NO HOT WATER

« on: May 03, 2015, 04:15:35 PM »

Check the reset button on the element thermostat if it is an electric heater.

365

Heatmor / Re: Heatmor 200ss dropin at year 19

« on: May 03, 2015, 06:59:31 AM »

I have welded 409 boilers with 309 wire or if the weld is not in the water jacket mild steel wire works. Electrolysis will eat out mild steel weld in the water jacket. 409 stainless is very repairable.