Hi all,
I've been experimenting with a technique for running my Optimizer 250 in warmer weather. Temperatures here are still well below freezing at night, but can climb above freezing during the day.
What I have been doing is loading the boiler full at night with all my pumps and heating circuits running normally, then shutting the boiler and all pumps off in the morning before going to work. I have radiant floor heat inside a concrete slab in a part of my home so the house doesn't cool off too much during the day.
Because I loaded the boiler full the night before, there is still a good amount of charcoal and charred wood in the firebox. When this charcoal burns, it doesn't produce any water vapor as the hydrogen part of the wood molecules have already been burned, leaving the carbon part to be burned next. This fact prevents it from leaking any water or condensation in the firebox during the day while it's shut off and the fire goes out. Then after I get back from work around 6:00 I turn the pumps back on but not the stove. The tank has stratified and I am pumping 180 degree water for a few hours. Before bed I relight the charcoal with a quick blast from the propane torch. The water temperature in the stove is now down to about 140.
I load it full of wood again for night and the stove then works fairly hard all night to bring the water, slab and house back up to temp. I repeat this process the next morning.
So far this seems to be working well. Am I missing anything that might be harmful to the stove? It seems to be a much cleaner way to burn in the shoulder seasons. I guess it's kind of like using storage, but not burning the wood batch completely. The tricky part is to correctly gauge the amount of wood needed at night to only have really charred wood and charcoal left in the morning so the firebox isn't full of steam all day.
Comments? Your feedback is always appreciated!