This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Shaver Furnace / Post up your Shaver pics

« on: January 03, 2012, 04:31:46 AM »

2

Shaver Furnace / On the slab

« on: May 17, 2011, 03:29:37 PM »

got it on the slab, still need to finish enclosure and pick up HE and a few other components.

3

General Outdoor Furnace Discussion / Can it be done - exchanger location

« on: April 10, 2011, 04:55:35 PM »

On my hot air furnace due to very low head room the supply duct is 12" high and 24" wide before branching. In that configuration there is no way to install a water to air exchanger.  I was thinking about a transition but that will put it at shoulder level in the way of a doorway, not really acceptable.

Has anyone used the return duct as it enters the furnace for the location of the exchanger, on that side it is 24"x24".

Thanks for any input

Ed