Welcome, Guest. Please login or register.
Did you miss your activation email?

Username: Password:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - allis48

Pages: 1 2 [3] 4 5 6
31
Equipment / Re: SAWS Wich ONE
« on: February 27, 2014, 05:33:25 PM »
I run echo saws and have real good luck. Lot of guys around here are switching to echo over stihl cause they are hard to start and the quality is starting to drop

32
Natures Comfort / What's causing the noise
« on: February 17, 2014, 08:43:44 PM »
What cause the actuator on the draft fan flapper to make a buzzing sound when it is actuated? It works just fine but it's driving me nuts a lot of times you can turn it off and turn it back on in the noise goes away. Any ideas on how to fix it?

33
Plumbing / Re: Frozen line
« on: February 01, 2014, 06:24:55 PM »
Yes yard hydrant. I put that in before building was heated, since it has been heated I never turn it off so the seal wouldn't go bad since the genius cemented around it. But the -24 below froze it up .

34
Plumbing / Re: Frozen line
« on: January 31, 2014, 02:13:54 PM »
I got it this morning!! I put the space heater on hydrant, got it good an warm then blew compressed air back threw it a couple of time ;)

35
Plumbing / Re: Frozen line
« on: January 31, 2014, 04:09:45 AM »
it runs water from house to the building, the building is heated but I think it froze either where it leaves the house or more than likely where it enters the building. Suppose to warm up tomorrow so hopefully I can get it thawed
It is plastic water line

36
Plumbing / Frozen line
« on: January 30, 2014, 08:25:12 PM »
I am looking for an idea on how to fall out the frozen water supply line that is underground?

37
Natures Comfort / Re: ok I have pump problems again any ideas
« on: January 27, 2014, 06:55:07 PM »
 I am running one taco and one b&g now so we will see which one last longer! I am getting good at changing pumps but getting tired of changing them

38
Natures Comfort / Re: ok I have pump problems again any ideas
« on: January 27, 2014, 04:40:03 PM »
I changed my fourth and final brodoer pump tonight in 0 degree weather went with a Taco pump this time couldn't find a grunfus so we will see how this goes

39
Fire Wood / Re: my wood cutting helpers and toys
« on: January 23, 2014, 09:10:21 AM »
You are correct it is T county

40
Fire Wood / Re: my wood cutting helpers and toys
« on: January 22, 2014, 10:41:53 AM »
Thanks Wood nutt! Neither one is mine thought , but I am teaching the oldest one to run saw, and ect.  They both do have cell phones and games but when they stay with me they are not a loud on them once the sun come up weather permitting

41
Fire Wood / Re: my wood cutting helpers and toys
« on: January 22, 2014, 08:35:45 AM »
sorry hit  same one twice   

42
Fire Wood / my wood cutting helpers and toys
« on: January 22, 2014, 08:34:41 AM »
the spreader works great for hauling wood

43
Site Suggestions / Re: cannot post pics??
« on: January 22, 2014, 07:34:54 AM »
Same here

44
General Outdoor Furnace Discussion / Re: How can I increase Ph level
« on: January 22, 2014, 06:28:24 AM »
How can I lower my Ph mine is over 11

45
Natures Comfort / Re: NCB-250 COAL
« on: January 03, 2014, 07:46:00 PM »
i put some lump coal on top of the wood when I fill it works just fine

Pages: 1 2 [3] 4 5 6