Welcome, Guest. Please login or register.
Did you miss your activation email?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
General Outdoor Furnace Discussion / Re: First boiler install
« on: October 18, 2017, 05:11:57 PM »
Thanks for the info/advice! I think I am slowly getting on track. I have a few more questions. I am looking to get a Grundfos 26-99. It will be about 70 feet from the boiler to the house. It seems that 1 1/4" is the proper size pipe? Do I have to keep everything 1 1/4" on the inside on the main loop? My plate exchanger for DHW would have to have 1 1/4" ports, right? I plan to go through the plate exchanger, then I also will have a 14x18 HX for my upstairs, and a manifold feeding eight 1/2" loops in my basement. Loops are less than 300'. Thanks!
2
General Outdoor Furnace Discussion / First boiler install
« on: October 13, 2017, 07:57:42 PM »
Hello all! Thanks for letting me in! I just purchased a P&M BL 2840, and this looks like the place to be! I have a lot of questions. I was wondering if there was a page somewhere or sticky thread that describes best practices for plumbing things up. I'm not doing anything too complicated--DHW, radiant basement slab, and HX for upstairs forced air. I am thinking I will do this off of one loop from the boiler? I'm just not sure what all components I should have, and how to configure them. Any advice greatly appreciated!
Pages: [1]