Welcome, Guest. Please login or register.
Did you miss your activation email?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
HeatMaster / Siemens controller
« on: November 19, 2019, 05:26:12 PM »
G200 ...3rd burning season
Anyone ever seen this??? went to load stove checked controller..... Stove calling for heat water temp at 159 & damper position at 7%....filled stove came back 30 mins later siemens controller still at 7% & water temp lower. I cut power off and restarted and the controller took off & worked like it should. This is the second time this has happened it did same thing last year. It's like the controller is stuck and my guess it would never change from 7% and eventually the fire would go out. Might just be a fluke thing.
Anyone ever seen this??? went to load stove checked controller..... Stove calling for heat water temp at 159 & damper position at 7%....filled stove came back 30 mins later siemens controller still at 7% & water temp lower. I cut power off and restarted and the controller took off & worked like it should. This is the second time this has happened it did same thing last year. It's like the controller is stuck and my guess it would never change from 7% and eventually the fire would go out. Might just be a fluke thing.
2
HeatMaster / Smoke bypass
« on: January 21, 2018, 02:08:25 PM »
I have a G200 with the siemens controller. With the door open and the smoke bypass lever pulled I have 5 minutes to have door open before the bypass fan cuts off. Is it possible to increase the 5 min timer as sometimes it takes me longer to dig around the ashes & fully load the firebox. I have tried to find the setting for this timer in the siemens controller but was unsuccessful. Also I know I am listed as a newbie but I heated my home with a Hardy H2 for over 16 years. I still can't believe how well the G200 performs and NO SMOKE. Thanks for any help.
3
Plumbing / Unrolling 100 foot Pex
« on: November 16, 2017, 11:43:57 AM »
I found easy way to uncoil a long roll of pex pipe and keep it straight was to run hot water through it as you unroll it. I hooked it up to my water heater and a hose. I turned the thermostat up on water heater somewhat Just overbend it on ends and hold it in place works great!
Pages: [1]