This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

General Outdoor Furnace Discussion / any decent wire brush solutions avail to clean an opti 250?

« on: August 29, 2014, 07:42:02 AM »

i believe the horizontal tubes are a 5/8 in brush and the vertical take a 2 in.  the manual push back and forth and up and down takes to much effort if you let it go past a few weeks and i cant always get to it each week.  i created a rod with a wire brush driven by a drill which is easier but i was hoping to get something that is a better solution.  someone on the board mention he sells a coil brush but that phone # is not working.  any suggestions?