Print

[mlappin]

Apology accepted for that, now how about a little chat with Darrin Pryzbilla AKA Wreckit and Jonathan for their comments on here as well!

They’ve been warned.

[slimjim]

Thank you!

[Trump2020]

well well i see nothing has changed here  Same bullcrap and same bitching. I hope the person with the crapty boiler gets taken care of

[slimjim]

Well well well, it seems that now he finally is being taken seriously by HeatMaster and they have made an offer but it’s a shame that he had to go to this extent huh?

[Trump2020]

Glad to hear its being resolved

[Trump2020]

new boiler?

[slimjim]

No

[mlappin]

Marty, you actually took the time to research what the membership levels of all those sites were? But you can’t find the time to read the first page of this thread even after accusing me of being the culprit!
Wow, just plain WOW, it’s time for a change!

Perfect example here, open Facebook on the smart phone, touch the groups icon, tap a group, scroll to the top of the page, each group has the number of members listed. Took me less time to check on member totals than it did to post here.

The forum software just needs changed to something else, I don’t think updating it is enough.

However I’ve also been a member of another forum that changed software, a lot of stuff was lost and was gone forever during the transfer.

[ticapa]

Update to all!

I worked with Ryan this year and a dealer in Eastern NY and we have resolved this issue.  Upon cleaning out the furnace in 2020 the deterioration has not gone away and was slowly growing. Ryan and his team deserve a lot of credit for helping and working with me.  We removed the old furnace and he located one here in NY that we where able to swap with.  I have not heard if the old furnace made it back to the factory yet of not. 

So with some modifications and plumbing upgrades we are now heating with a G400 again.   For all that are wondering about some of the upgrades.  I put in a hot water mesh screen with drain and bypass in the main house circuit to help get the fines out before the heat exchangers.  we also relocated circulators to back of the unit and put in line temperature gauges.   All is working well and temperature drops and stack temperatures are exceptional.

Thanks again to Ryan and Heatmasters for correcting a bad situation and helping me.

[E Yoder]

Good to hear!