Outdoor Wood Furnace Info
Outdoor Furnaces - Manufacturers WITH EPA-Certified Models => HeatMaster => Topic started by: Jon_E on December 07, 2017, 08:51:01 AM
-
This may be a dumb question but I want to hear from you guys with G-series boilers. I have cleaned the ash out of the firebox of my G200 simply by raking the stuff through the slot in the bottom of the firebox and dragging it out through the door on the secondary burn chamber. I use the little half-moon shaped tool/rake that they give you. What I have not figured out, though, is how to clean, or even see, the section of firebox that is right inside the firebox door. In other words the front wall and the front 4-6" of the firebox. I can't really get in there to see if there's a lot of creosote or ash built up just inside the door.
Does anyone have any good ideas on how to view this area and clean it out?
-
Yes, it's kinda hard to see. I usually let the fire burn down once a month or so and check those kind of places out. In the spring I do a more thorough cleaning.
-
Yep, I have a old poker that was used wit the original coal furnace in the house, has just the right curve I can run it across the front of the stove as well to make sure the ash is loose. To clean that part I use a small camp shovel, maybe 18” long total?
-
Jon e.
I use a piece of 1/2” solid stock. Make a L. 4” 80degree bend in the hot end. From there come up 15” make a 8-10deg bend in same direction as end. Handle end I bent a big oval enough to get a glove into and welded the joint. Length when done is about 45”. This works very well to get the ash away from the corners and out from underneath the heat curtains.
Remember to keep the heat curtains cleared on the bottoms.
Also works very well to move hot chunks of wood and coals around when you get a bridge. You can slide it right between the chunks of wood and flip them around.