This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

31

Plumbing / loose threaded fitting?

« on: April 26, 2011, 06:29:45 PM »

I'm changing out some 3/4 inch valves on the back of my Shaver Furnace and replacing them with 1 inch valves.  I have one of the pipes coming from the furnace that seems to be slightly smaller than the others.  I tried using some extra teflon tape but still had the threaded pipe go in to the elbow too far.  Does anybody know if there is a extra heavy joint compound to make up the difference?   

32

Electronics / low water warning light?

« on: April 24, 2011, 07:41:21 PM »

I am interested in buying a low water warning light, does anybody have any suggestions?

33

General Discussion / low water warning light

« on: April 24, 2011, 07:36:28 PM »

I would like to put a low water warning light on my Shaver 290 OWB.  Does anybody have a suggestion on where and what kind to get?  Thanks,
 

34

Shaver Furnace / Fan opening - draft control

« on: November 04, 2010, 03:55:02 PM »

Last year I ran with my fan open almost the whole way, this year I am trying to cut it back to 50 % open and running the water temperature at 180.  Just wondering what other guys are doing.     

35

Shaver Furnace / Re: Any Satisified Shaver Owners ??

« on: January 23, 2010, 05:59:25 PM »

I'm very satisfied with my Shaver 250.  It heats my house, my domestic hot water, my son's house and his domestic hot water.  I also use it to heat our inground pool in the summer.  This is our second winter with it and it is doing great.  Our furnace rarely kicks on, and our gas bill is at the minimum.