This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Shaver Furnace / Re: My Shaver is a mess

« on: January 30, 2012, 05:39:03 PM »

Get the 75 cfm blower with solenoid.  i think you can get it from altheatsupply.com.  Hope this helps.

2

Shaver Furnace / Re: Burning coal in a Shaver 250 furnace

« on: January 23, 2012, 07:32:16 PM »

I use a coal and wood mix.  I usually put about a 5 gallon bucket of coal in the bottom then stack wood on top of that.  I never have to fill it up more than twice a day and for the most part only once because its not really been that cold here.  I only put the fuel in the front of the stove I never put anything in the back half.  I have the shaver 290 coal series.  Hope this helps.

3

Shaver Furnace / Re: HWT - Help

« on: December 24, 2011, 08:22:27 AM »

Guys I have been a reader on this site for over a year and I purchased a shaver 290 coal series and did all the mods that I read on here and I did them when I was hooking it up this past summer and I have had zero problems.  I am extremely thankful to all the people that has posted on this site because it made it alot easier for me.  As for the hot water heater I used the original thermostat that was on it.  I just turned the breaker off on it and unwired the bottom stat and then hooked the pump to it.  Works great.  People complaint about the shaver alot on here but besides the shabby metal work on the sides I have had no problems at all  I love it.  Thanks for all the info from the forum in the past it helped me trememdously.