Outdoor Wood Furnace Info

Outdoor Furnaces - Manufacturers WITH EPA-Certified Models => Hardy => Topic started by: slosh250 on October 15, 2012, 04:32:21 AM

Title: Setup Help
Post by: slosh250 on October 15, 2012, 04:32:21 AM

Ok here's my issue. I ran 3 pipes to my house with thermostat wire, 3 pipes to my shop, thermostat wire and 12/2 for power And i have 1 lines coming from my well house for cold water supply for the autofill and water for dhw. I was told before on the other site i could just run 1 line for my DHW on demand with a pump.The part where i'm scratching my head is should i run my entire loop(around 300ft)in a single loop or put a tee off my pump and run 2 loops with one pump (thats how hardy did my father in laws) and have them return in 2 seperate location on the ports on the bottom or my hardy? wish i had a picture to help everyone understand it better , maybe someone has the same type of setup and could chime in. thanks

Title: Re: Setup Help
Post by: AirForcePOL on October 24, 2012, 07:27:10 AM

I'm really confused about your set up... could you maybe draw a diagram in paint or somethin?

Title: Re: Setup Help
Post by: slosh250 on October 28, 2012, 07:32:32 PM

not good at diagrams. got all the piping hooked up now just gotta get the wiring done.