Welcome, Guest. Please login or register.
Did you miss your activation email?

Username: Password:

Author Topic: Setup Help  (Read 2406 times)

slosh250

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 71
    • View Profile
Setup Help
« on: October 15, 2012, 04:32:21 AM »
Ok here's my issue. I ran 3 pipes to my house with thermostat wire, 3 pipes to my shop, thermostat wire and 12/2 for power And i have 1 lines coming from my well house for cold water supply for the autofill and water for dhw. I was told before on the other site i could just run 1 line for my DHW on demand with a pump.The part where i'm scratching my head is should i run my entire loop(around 300ft)in a single loop or put a tee off my pump and run 2 loops with one pump (thats how hardy did my father in laws) and have them return in 2 seperate location on the ports on the bottom or my hardy? wish i had a picture to help everyone understand it better , maybe someone has the same type of setup and could chime in. thanks
Logged

AirForcePOL

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 864
  • OWF Brand: HeatMaster
  • OWF Model: G400
    • View Profile
Re: Setup Help
« Reply #1 on: October 24, 2012, 07:27:10 AM »
I'm really confused about your set up... could you maybe draw a diagram in paint or somethin?
Logged
Athens, Illinois
Dealer for HeatMaster SS
Stihl MS 290
Troy Bilt 27 ton splitter

slosh250

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 71
    • View Profile
Re: Setup Help
« Reply #2 on: October 28, 2012, 07:32:32 PM »
not good at diagrams. got all the piping hooked up now just gotta get the wiring done.
Logged