Welcome, Guest. Please login or register.
Did you miss your activation email?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Equipment / Re: Baileys Husqvarna price match
« on: January 13, 2015, 11:55:00 PM »
They'll eat you up in shipping though.
2
Equipment / Re: new husky 555,driving me crazy
« on: January 12, 2015, 10:07:52 AM »anyone else have a newer model 555 husky saw, dam fuel injection, why don't they just leave old school alone...now you need a laptop to re set it....
EPA
3
Equipment / Re: new husky 555,driving me crazy
« on: January 11, 2015, 09:23:24 AM »
Love my 562xp. What issues are you having with your triple nickel?
4
General Outdoor Furnace Discussion / Re: Moisture meters
« on: January 01, 2015, 02:12:03 PM »
Lowes. 25-20% is good. Anything under 20% is great
5
Fire Wood / Re: Any Tricks to Burning Green Wood
« on: December 16, 2014, 11:51:23 AM »
Solar kiln. Start with a pallet or two. Lay down clear plastic sheeting 10x25' roll and cut slits in the bottom to allow drainage. Stack your wood on it, then cover with remaining sheeting. Be sure it is and area that will get the most possible sun. Radiant heating will draw out moisture and it will drain down the sides of the plastic and drain out the bottom slits. Don't expect a miracle but if you can leave it a month or 2 it will pull off a lot of moisture.
6
General Outdoor Furnace Discussion / Re: Burning green wood stinks...
« on: November 26, 2014, 10:21:24 AM »
That is why I'm working on getting 3 years ahead. Green wood only gives us OWB burners a black eye.
8
Site Suggestions / Re: Cant login
« on: October 19, 2014, 06:45:11 PM »
Same problem here. Currently logged in on my tablet with my saved user name and password. However no success logging into on my account on my phone or PC.
9
Fire Wood / Re: TYPE of CHAIN SAWS USED
« on: April 20, 2014, 07:10:42 PM »
Cut my teeth, or should I say first wood with a Stihl MS250. I have since added an MS261c. May soon round out the 40/50/60cc trio with MS362c or 562xp.
10
Equipment / Re: Fiskars Axe
« on: March 09, 2014, 07:09:34 PM »
Love my Fiskars. I have 2 the x25 and the x27. Bought the x25 first as it was all they had at my Walmart used it for about 6 months but felt it was a little to short. Found the x27 and now I just keep the little x25 on the four wheeler for those times I need a splitter in the field.
11
Electronics / Re: Temperature monitoring.
« on: February 12, 2014, 09:42:55 AM »
The reason I want it at the OWB is to monitor high/low temp conditions. Not sure placing it at the heat exchanger would give me enough warning time of a boil over or fire out condition.
12
Electronics / Re: Temperature monitoring.
« on: February 09, 2014, 07:45:21 PM »
Ordered the Maverick ET732. Should be here in a few days.
13
Electronics / Re: Temperature monitoring.
« on: January 31, 2014, 12:31:24 PM »
Muffin, thanks for the input. Are you using the single prob model or dual prob?
14
Electronics / Temperature monitoring.
« on: January 22, 2014, 11:53:26 AM »
Hello all. First time poster with a Hardy H2. I am looking for options on remote temperature monitoring. All I wasn't too do is have the ability to monitor high/low temp at the OWB. In the event of low temp such as fire out, or high temp because of a stuck flapper or door open. I have looked at the digital readout that RSI sells as well as a wireless BBQ monitor. Abby and all suggestions welcome.
Pages: [1]