Outdoor Wood Furnace Info

All-Purpose OWF Discussions => Plumbing => Topic started by: aries9245 on December 15, 2014, 04:19:23 AM

Title: Circulator before water to water HX
Post by: aries9245 on December 15, 2014, 04:19:23 AM

I just finished repiping.. The inside loops ok what I did was create a primary and secondary loop so Rees the setup..
Starting at the boiler  line out 1 1/4"  to spirovent next expansion tank followed by a taco 007 primary circ next first t to baseboard zone next t within 6" return for baseboard zone going to radiant heat 3 seperate zones all return within 6" followed by a taco 008 into a 70 plate HX back through propane furnace .. So here my question my OWB line coming in is 180 deg but after it goes through HX loops around to my baseboard zone it's only 160 deg from what I remember before I did this I was only loosing 6-8 deg from HX so am I undersized at my circulator going into HX?