Outdoor Wood Furnace Info
Outdoor Furnaces - Manufacturers WITH EPA-Certified Models => Central Boiler => Topic started by: Scratch on December 21, 2008, 10:06:08 PM
-
So this is my first couple of days using my 6048 Central Boiler. I fill it with wood, leave the door open a while to get it going, and let the temp get to about 160 or so. I shut the door and leave. I come back in about an hour and it's up to 165. Makes sense to me...
About 3-4 hours later, I come back and the temp is down to like 135. I open the door and the wood is barely burnt...? I think I checked and the damper setting was 185. I can hear the door is open every time I come out there. And I know it's open because I can see through it.
Is this working normal....?
What temp should it be at, I would think it would try to keep itself at the setting which I think was factory set at 185. I'm using nice dry wood, but it's not split, some is about 12-15 inches around and most are cut to 12-24 inches long.
-
First day firing my boiler, i used very dry- small split pieces, no rounds. Continued this till a hot coal bed had developed. Then was able to burn full size split or unsplit wood. Boiler temp will fall to @10 degrees below setpoint before damper opens. With a good hot coal/ash bed in boiler u should have no problems.. good luck!! keep us informed..
-
That might have been it. I came home from work today and the temp was up to 180. Maybe the bed of coals is what I needed. After all... It's only been going for less than 48 hours or so... ::)