Outdoor Wood Furnace Info
Outdoor Furnaces - Manufacturers WITH EPA-Certified Models => Central Boiler => Topic started by: merrellroofing on October 22, 2011, 08:53:37 PM
-
I am almost done putting everything together on my 6048. Trying to plumb in a second pump for my shop and I can't get the plugs out of side of the unit. They are square headed, which I will never understand, and they are set in too far to get any kind of wrench on very well. I am reluctant to put the heat to it for melting the spray foam. I bought it used 2 years old so it had some time to heat up or rust up. Thought about trying to hole saw them out and pry the threads out nicely but not sold on that plan either. Any suggestions welcome
-
perhaps a piece of square tubing that will fit the head of the plug would work or a 12 sided socket may get in the space
if it is a 1/2 inch square or 3/4 square head, you could possably slide the "wrong" end of an extension bar for a socket set over it and then use the right side wrench to turn the square end of the extension or use a pipe wrench. just a few suggestions that may help you out..good luck
-
weld a 1/2 ''nut to fitting ..plug weld the center of the nut,cool it with a wet rag. let it cool down a bit then try it .a impact gun will work better if you have one.
-
The same thing happend to me ! I cut back the spray foam and got a pipe wrench and a small sledge hammer and it came rite off. Then i painted where i cut the spray foam away to protect the steel!
-
I bought one of these: http://www.grainger.com/Grainger/PROTO-Impact-Socket-1AX17?Pid=search (http://www.grainger.com/Grainger/PROTO-Impact-Socket-1AX17?Pid=search)
It MUST be 8 point!!!
It got it right out. I am a master auto tech so I have "many" ways to get jobs like this done......but in the end, after I tried many ways, getting the proper socket WAS the only (and easiest way).
BTW At this point, I don't remember exacty WHAT SIZE the plug was. I only showed 15/16" for illistrative purposes. Get an open end wrench and see what size it really is. Grainger was the only place I could find one due to the odd size of the plug.
And let's face it....you can never have too many tools :thumbup: