Outdoor Wood Furnace Info
All-Purpose OWF Discussions => Electronics => Topic started by: Bull on November 18, 2011, 06:10:27 PM
-
As the title says my thermometer came in and I hooked it up to the pex going into and out of the heat exchanger. I used aluminum tape and put the foam insulation back around it. Not sure how accurate of a reading I am getting through the pex but it looks like I am losing about 6 degrees from the stove to the htx and about 14 between incoming and outgoing with the blower running.
It's a Mavrick model ET 7 remote check
-
Do you have any copper you can put it on instead? Pex is going to give you a lower reading.
-
After it being connected all night this morning I checked the aqustat on the OWB and it is the same as the mavrick.