Outdoor Wood Furnace Info

All-Purpose OWF Discussions => Plumbing => Topic started by: pops69 on September 19, 2014, 05:47:08 PM

Title: unbending logster
Post by: pops69 on September 19, 2014, 05:47:08 PM

Does anyone know how to"unbend logster"? I have a trench, Logster in the trench, but going thru the foundation its bent, I don't know if I can get my Link seals to fully seal with the bend pressure coming thru the wall.
Thanks

Title: Re: unbending logster
Post by: Jwood on September 19, 2014, 07:10:07 PM

Do what you have to do to go straight through the wall.

Title: Re: unbending logster
Post by: coolidge on September 20, 2014, 08:43:44 AM

Ahhh.  That stuff must be a B!:ch to deal with in the cooler weather, I unrolled mine on one of those HOT. Days and let it bake in the sun a few weeks. Warm it up if possible.

Title: Re: unbending logster
Post by: atvalaska on September 23, 2014, 03:09:55 PM

we used a weed burner to  get ours ..happy

Title: Re: unbending logster
Post by: hoardac on October 04, 2014, 08:26:35 PM

I tied mine to my 4 wheeler and a tree pulled it tight, let it sit for a week in the sun, helped quite a bit.

Title: Re: unbending logster
Post by: Pinehouse4 on October 27, 2014, 06:49:18 PM

I don't know if this will help you with your particular problem but I was able to make it a little bit easier to work with by running straight hot water via a hose over the section required. Give it 10 minutes of maximum hot water and then be prepared to work it with gloves.

Bob

Title: Re: unbending logster
Post by: treeeman00 on October 27, 2014, 07:29:07 PM

I did mine by myself in 30-40 degree weather.  I stood the roll upright in the trench and got the end started through the hole in my wall using a crowbar then unrolled.