Outdoor Wood Furnace Info

Outdoor Furnaces - Manufacturers with NON EPA-Certified Models Only => RidgeWood Stoves, defunct, support only => Topic started by: rsheeks on December 30, 2014, 06:35:50 PM

Title: Finally Joined
Post by: rsheeks on December 30, 2014, 06:35:50 PM

Been in the side lines finally got accepted to the site. got my 7500 this fall love the thing so far had a few things goofy but end result was the installer. ME! stove is 170 feet from house 2000 sq ft, got the bigger pump running on position 2. heating portion of my shop with home made air handler on a as needed switch, small pump position 1. went with sidearm for hot water think i have it to high water don't last long like everyone says. Used all pex and a few Sharkbite valves all runs have bypass rigged.
Hope everyone stays warm!
bob

Title: Re: Finally Joined
Post by: Roscoe on December 31, 2014, 06:20:25 AM

Welcome Bob, where u located?

Title: Re: Finally Joined
Post by: Jwood on December 31, 2014, 06:57:44 AM

Hello Bob!

Title: Re: Finally Joined
Post by: Chas on December 31, 2014, 07:34:10 AM

Hey Bob....Welcome to the Ridgewood and OWB family. Sounds like you have a nice setup with the 7500.  People on here will give you advice on your sidearm if you need some.

Title: Re: Finally Joined
Post by: slimjim on December 31, 2014, 08:53:42 AM

Welcome aboard Bob!

Title: Re: Finally Joined
Post by: Shrek1112 on December 31, 2014, 09:24:11 AM

Welcome Bob, as a fellow newbie I am sure you will find this forum highly useful and the wealth of knowledge that many members possess and are willing to share.   :thumbup:

Title: Re: Finally Joined
Post by: ffbare on January 03, 2015, 07:29:31 AM

Welcome
To the site.