This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

General Outdoor Furnace Discussion / Re: Stupid question about mahoning owb

« on: November 29, 2013, 07:51:59 PM »

No worries guys, I'm just gonna have to call them up and ask, I thought I'd run into someone else that has a mahoning I'll be sure to post it on here when I find out, thanks everybody

2

General Outdoor Furnace Discussion / Re: Stupid question about mahoning owb

« on: November 29, 2013, 04:30:43 PM »

Yeah maybe that's what it is. I honestly can't figure it out I've looked the stove over a dozen times and can't see anything u would use it for.

3

General Outdoor Furnace Discussion / Re: Where's a good online place to buy new plumbing parts, heat exchangers, fittings

« on: November 28, 2013, 08:15:08 PM »

Check out eBay I picked up my heat exchanger for 80 on there and 200 ft of pex for a hundred

4

General Outdoor Furnace Discussion / Stupid question about mahoning owb

« on: November 28, 2013, 08:07:53 PM »

Hi everyone. I have a mahoning 250 owb that I recently installed when I purchased the stove it came with shovel, poker, and a little stainless steel box. I have no idea what the little box is for it's only about 3 inches deep and about 5 inches long. Any ideas anybody? I'm baffled where it goes or what it is for. Thanks

5

Electronics / Re: Blower issues

« on: November 12, 2013, 12:50:26 PM »

Also is there a way to wire the thermostat to automatically
 kick on the blower

6

Electronics / Blower issues

« on: November 12, 2013, 12:41:08 PM »

I have recently hooked up a mahoning owb putting a heat exchanger in my plenum of my existing oil furnace, I have ran all my wires out to the relay and went over the schematics a million times, I turn on my thermostat my water circulator turns on to circulate but my furnace blower won't kick on, both wires on the blower are black and I have tried hooking up to each of them and still nothing, am I supposed to wire into both of them? On the wiring diagram it only shows going to one of them. I'd appreciate any help thanks

7

General Outdoor Furnace Discussion / Re: installing help

« on: November 03, 2013, 06:59:49 PM »

so my question is there are two circulating pumps, i am only hooking to a heat exchanger in my plenum so will only be using two water lines. which pump should i hook up to and which return line do i use, from the picture above it looks like the left pump is a little bigger and it has a temp gauge mounted in it, but the one on the right at the bottom it has a ball valve on it so i really dnt know where to hook my water lines at? and if im only using the one pump do i just unplug the other one and close the valve for it? and my other question is for hooking up my thermostat to it, its a two wire thermostat red and yellow. there is a transformer if u look at pic above mounted on the electric box where the pumps are plugged into and if u look at the other pic there is a little relay box that sits just below pump. hope the pictures help out thanks

8

General Outdoor Furnace Discussion / Re: installing help

« on: November 03, 2013, 06:45:56 PM »

This is one of the relay boxes kinda hidden under the pump

9

General Outdoor Furnace Discussion / Re: installing help

« on: November 03, 2013, 06:44:09 PM »

This is the back of the stove

10

General Outdoor Furnace Discussion / installing help

« on: November 02, 2013, 09:08:27 PM »

i just purchased a mahoning 200 and i cannot find any info on how to install,  im going to use a heat exchanger in my plenum, im not going to hook up my hot water tank this year, but there are two pumps in the back of the boiler does it matter which one i use? or is there a main one im supposed to hook up to? second question is on  the thermostat, i was going to hook my existing thermostat and just disconnect it from oil burner and run it to the woodstove, i have a transformer in the back and a relay anyone know which wires go where? i have emailed mahoning but have gotten no responses and one of the guys was supposed to call me back but nothing from him either. any help would be greatly appreciated. i have searched the internet and cant even find a manual anywhere thanks in advance.