Welcome, Guest. Please login or register.
Did you miss your activation email?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Electronics / Re: Blower problems
« on: January 04, 2012, 04:37:57 PM »
Could be getting creosole on it. I do burn a lot of green wood. As for the starter compasiter, I'm on my third blower in 14 months. All the same brand and model because they had a 1 year warranty and I've just been sending them back.
2
Electronics / Blower problems
« on: January 04, 2012, 01:06:58 AM »
First post here.
I have a homemade owb that my uncle built for me in 2010. Im on my third blower. They run fine for a month or two then have the following problem. The blower does not kick on when it should per aquastat. However if I take something and spin the the wheel on the blower by hand it takes right off. The blower is a Dayton 1TDP3. I did notice it is only a 50cfm, which is smaller than most being used on this forum. Any help would be greatly appreciated. Getting tired of going out in the morning and my water temp being cold.
Thanks
Chris
I have a homemade owb that my uncle built for me in 2010. Im on my third blower. They run fine for a month or two then have the following problem. The blower does not kick on when it should per aquastat. However if I take something and spin the the wheel on the blower by hand it takes right off. The blower is a Dayton 1TDP3. I did notice it is only a 50cfm, which is smaller than most being used on this forum. Any help would be greatly appreciated. Getting tired of going out in the morning and my water temp being cold.
Thanks
Chris
Pages: [1]