Welcome, Guest. Please login or register.
Did you miss your activation email?

Username: Password:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Kpatton

Pages: [1]
1
Plumbing / Re: Plumbing
« on: October 22, 2012, 05:08:49 AM »
Anyone have pics of there manifold to see how one would look. Is it to much to take three secondary loops off the primary cercercet

2
Plumbing / Re: Plumbing
« on: October 18, 2012, 05:32:44 AM »
If I use manifold do i run throw it to DHW ex and then back strait throw the return manifold and back to owb. Then separate pump for all other zones. Thanks for any info I new to all this heat plumbing. Would I need to have air seperater for all zones,& check valves ?

3
Plumbing / Re: Plumbing
« on: October 17, 2012, 08:17:34 AM »
Thanks I think that what I will do planing on maybe four zones 3 in house and one to garage to over head air handler. Anymore I site wellcome.

4
Plumbing / Re: Plumbing
« on: October 15, 2012, 10:42:12 AM »
How would I do it with separate pump?

5
Plumbing / Re: Plumbing
« on: October 15, 2012, 04:57:33 AM »
I guess I will hook owb right to baseboard . how do I control heat in house? Do I use a zone valve and bypass loop? :bash:

6
General Outdoor Furnace Discussion / Re: Hx
« on: October 15, 2012, 04:48:26 AM »
Ok thanks for info. Let pump run 24/7 & use zone valve to stop from heating baseboard when house up to temp. should do bypass  at valve to send water back to owb when house at temp.

7
General Outdoor Furnace Discussion / Re: Hx
« on: October 14, 2012, 07:50:58 PM »
It will be open to air not presureized system. That is ok.
Should I have pump on owb wired to run 24/7 or to come
on when heat is needed.

8
General Outdoor Furnace Discussion / Hx
« on: October 14, 2012, 07:18:54 AM »
Have no boiler inside do I need Hx or can I tie owb right right
To baseboard with zone valve and bypass loop for when heat
Is not needed.

9
Plumbing / Plumbing
« on: October 10, 2012, 10:31:51 AM »
Does anyone have suggestion on how to plumb inside no boiler
In house just electric radant in sealing. Was go to do baseboards
any info would be good. Have ex for DHW   Do
I need one for baseboard on do I huck up direct to odb?   :bash:

Thanks everyone

10
Testing / Re: hello
« on: October 10, 2012, 10:14:42 AM »
 :pic: :post:

Pages: [1]