This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Plumbing / Re: Z-Supply llc

« on: March 02, 2013, 09:44:58 AM »

yes! I used the 3 wrap  on my install and i am only losing about 1 deg in a 60 foot run! Ridgewood didn't offer the 5 wrap when i bought my pipe!

2

General Outdoor Furnace Discussion / Re: would this work?

« on: March 02, 2013, 09:35:40 AM »

i would say try and c what happens! as u know my stove is a natural draft and seems to work fine, how ever the opening is larger! i run my stove at 160 with all in floor heat!

3

General Outdoor Furnace Discussion / Re: would this work?

« on: March 02, 2013, 09:27:00 AM »

i would say yes-  but i could b wrong ! i would unplug fan and pull the heat out of stove untilthe stove calls for heat  and c how long it takes to recover!

4

General Outdoor Furnace Discussion / Re: would this work?

« on: March 02, 2013, 09:11:44 AM »

victor ! I believe it will work however your recover time will b a lot longer! just my opinion!

5

General Outdoor Furnace Discussion / Re: Ridgewood stoves

« on: February 26, 2013, 05:54:39 PM »

just wondering if automan got his stove hooked up?

6

General Outdoor Furnace Discussion / Curious About Coal

« on: February 25, 2013, 04:18:22 PM »

Can you burn coal in a stove without grates? Is it better to burn either all coal or all wood, or is it ok to mix the two?

7

General Outdoor Furnace Discussion / Re: Set-Back Recommendations

« on: February 25, 2013, 04:00:35 PM »

Not all insurance companies require listing!

8

Home Made / Re: Install of homemade outdoor wood furnace.

« on: February 16, 2013, 05:49:46 PM »

turn pump on low speed

9

Site Suggestions / Re: ridgewoodstove

« on: February 16, 2013, 05:24:40 PM »

not sure y they are not on here! 

10

General Discussion / Re: Door Gasket

« on: January 23, 2013, 06:57:24 PM »

When I first got my stove 2 years ago, the gasket seemed hard as well. I spoke with the company owner and he suggested wetting it a little and making sure the door was tunked down nice and tight. Worked well for me, my gasket formed around the door frame better, no trouble since!