This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

General Outdoor Furnace Discussion / Re: cleaning firebox

« on: November 01, 2015, 07:15:42 PM »

Thanks for the info, Ill try it !

2

General Outdoor Furnace Discussion / cleaning firebox

« on: November 01, 2015, 10:28:45 AM »

Almost time to fire up. Is there a way to get stubborn creosote off sides of firebox inside? I tried scrapping , but still hard as a rock? Any suggestions? Heatmore 200cs Thanks

3

Electronics / Re: aquastat and high limit switch

« on: October 26, 2013, 06:20:22 PM »

thanks for the info you have been a great help.

4

Electronics / aquastat and high limit switch

« on: October 26, 2013, 05:59:37 AM »

I'M GETTING READY TO FIRE MY HEATMOR 200 AND PUZZLED ABOUT AQUASTAT? IN MANUAL IT SHOWS AQUASTATS ON BACK OF OWB-A HIGH TEMP ANS A LOW TEMP SETTING. ON THE BACK OF MINE THERE IS A1 AQUASTAT AND TO THE RIGHT A HIGH LIMIT SHUT OFF SWITCH. SO THE QUESTION IS HOW DO I SET THE HIGH AND THE LOW?

5

Heatmor / aquastat an high limit shut off

« on: October 26, 2013, 05:53:18 AM »

I am ready to fire up my heatmor 200css- in the manual it shows 2 aquastats on back of owb-mine ha s1 aquastat and to the right a high limit shutoff switch.how do I set high and low water temp?

6

Plumbing / Re: PEX Install Questions

« on: September 23, 2013, 05:46:31 PM »

Was wondering if anybody has a good source for 1 1/4 PEX. I need 125 ft to complete inside install.Thanks Also, any tricks to air testing lines from house to wood boiler? I need to rig up something ..

7

Plumbing / help on hook up owb to a system 2000

« on: August 25, 2013, 05:27:44 AM »

Looking for help on hook up to system 2000 boiler. Any install stories? Have a schematic from System 2000. It's very confusing.. Thanks ..

8

Heatmor / Re: Hello fellow heatmor owners!

« on: June 09, 2013, 06:47:22 PM »

has anyone installed and hooked up a heatmor  to system 2000? I have a 200css on the way