This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

General Discussion / Re: Message Board - How To

« on: September 15, 2013, 11:29:12 AM »

dont know if this is the right place or not. i need help with the best way to repair my wood furnace. i am a welder just need input on the best way. got a couple of ideas. it is a flame master purchased in indiana in 2006. round inside round design. with supposedly a quarter inch thick fire chamber. was cleaning it out today and found out why the ashes were damp. there is a small hole 2 inches from the rear wall almost in the center of the fire chamber. any info would be greatly appreciated. by the way im glad i found this site. havnt had internet for about 4 years.