This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

General Outdoor Furnace Discussion / Re: converting garage heater (hanging oil to air) to wood burner

« on: December 01, 2013, 05:41:32 AM »

For piping look up Scott7M here on the forum and get some Logstor from him well worth the money.  Just make sure you have good help when you put it in it's a bear to work with.

2

Hardy / Re: H-4 I beams

« on: November 24, 2013, 06:37:53 PM »

This spring when i shut mine down for maintenance. I believe I'm going to fill the area with sand ala Heatmor setup.  Will act as an insulator and keep ashes and such from building up down there.

3

Plumbing / Re: Baseboard Setup

« on: October 14, 2013, 05:42:28 PM »

Valves and yeah you are right i thought about that after I drew those pictures up.

4

General Outdoor Furnace Discussion / Lifting a Hardy

« on: October 13, 2013, 06:12:46 PM »

I recently purchased a used Hardy at junk price. The unit appears to be in working order. I have access to a work truck with a crane on it and was wondering if there is a place to lift the unit once you take off the outer shell? If not what would be the best way to move the unit

5

Plumbing / Baseboard Setup

« on: October 13, 2013, 06:10:50 PM »

I recently had the oportunity to buy a used Hardy at a very good price. Do to the odd layout and age of my home I have decided not to use duct work and to install baseboard heaters. Right now I am throwing around a few ideas on how to hook them up any input would be appreciated. I attached 3 pictures let me know which you think would be best. First and third my cir pump would run all the time.