This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

General Outdoor Furnace Discussion / Re: looking for parts for Timber Ridge Free Heat Machine

« on: February 13, 2014, 03:51:28 AM »

Thanks so much

2

General Outdoor Furnace Discussion / looking for parts for Timber Ridge Free Heat Machine

« on: February 12, 2014, 04:24:29 PM »

I have a model 200 forced draft stainless steel boiler from Free heat machine and I am looking for parts. More specifically, a door gasket. I'm having issues with the boiler rattling and the boiler hasn't reached set point. I adjusted down the aqustat and still have the same issue. I did notice a little smoke leaking from the bottom left hand corner of my door.
Thanks

3

General Outdoor Furnace Discussion / Re: Help with ductwork

« on: February 12, 2014, 04:15:07 PM »

Yes, there are retailers where they can be purchased in the size you specify. Titus products is one vendor that carries back draft dampers. You will have to find a Titus rep in your area and discuss with them. I am from the Washington DC area and there is another vendor in Maryland called CG Woods and they too can get whatever size back draft damper you need. The dampers normally come as a slip in installation. You will have to cut an access door at the point you will want your damper and install some light gauge angle on all four interior sides of your ductwork in order to fasten the damper.
Hope this helps.