This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Central Boiler / Re: Losing 12-15 degrees from Boiler to house... before hitting heat exchanger.

« on: January 29, 2014, 07:33:46 PM »

Noce sit up - what type of filters you are using?

2

Central Boiler / Re: cental 5036 temp isues.

« on: January 24, 2014, 06:03:25 PM »

I had the same thing happen to me.  Reading would be high (but my temperature gauges would 30 to 40 degrees lower).  Then as soon as I jarred the door the controler sets in, the reading would drop to match the temperature gauges.  I checked for loose wires wires and the thermistor (1000 ohms at 25 degrees C) - everything was okay.

I changed out the controller (purchased it on ebay) and installed a surge protector.  It has been working great.

3

Site Suggestions / Re: cannot post pics??

« on: January 22, 2014, 02:51:26 PM »

same here I can not even post pictures in the gallery even after resizing them.

4

General Outdoor Furnace Discussion / Re: replacing rope seal...silicone?

« on: January 21, 2014, 07:23:04 PM »

Silicone rope gasket - does it come in 7/8" diameter?

Any info on the material - internet site?

5

Central Boiler / Re: Black CB

« on: January 09, 2014, 06:16:17 PM »

I have an all black CB 5036. can not attach a picture.  However the picture is my gallery - CB5036

6

Central Boiler / Anybody have the CB e-classic 2400?

« on: March 20, 2011, 08:42:30 PM »

I looking to purchase a gassification OWB.  Anybody have any experience with CB eclassic 2400?  I am looking to heat a 5000 sf home that was built in 1992 & DHW.  Forced air heat, insulated basement walls.  I have 12 full cords of two years plus seasoned wood that has been stored in a barn.

7

Plumbing / Brass and steel connections

« on: February 02, 2011, 10:14:24 PM »

I plan to replace the 3/4" steel plumbing on the back of my steel boiler with larger diameter brass fittings.  I was wondering  any corrosion problems that may develop?  I have a free stash of brass fittings available.