Welcome, Guest. Please login or register.
Did you miss your activation email?

Username: Password:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - allis48

Pages: [1] 2
Natures Comfort / Water gauge
« on: January 30, 2019, 10:44:07 AM »
This the first season i have had this issue but since
Changing the water out this fall the gauge is all over the place
for no reason. This morning itís -2 and itís shot
Clear up

Electronics / Bp 200K HANGING HEATER
« on: January 27, 2019, 11:25:50 AM »
Does anyone have specs on an older Bp200k hanging heater. This one has the stepup step down converter onit with a 220v fan. I am wondering how many cfm's it is. I think my fan is going bad an slowing down after it runs cause I am no longer getting the heat out of it I once did.

Natures Comfort / Is this normal ?
« on: April 15, 2015, 03:38:17 AM »
][URL=http://s276.photobucket.com/user/kingquad450/media/Mobile%20Uploads/image_zpspiguli1q.jpg.html][/url]I was cleaning out my boiler with scrapers in a chipping hammer and it seems like a lot of scale  coming off is this normal? I sprayed it down with a mixture of diesel fuel in gear oil at the end of every season to help it from rusting.

Fire Wood / what's better to burn
« on: January 31, 2015, 07:55:04 AM »
Short split pieces or just big long logs? seems like I am going through a lot of wood compared to years pasted but it's all small stuff.

Fire Wood / poles
« on: January 06, 2015, 08:02:00 PM »
Anybody ever burn old telephone poles? Got couple left by the power company should I burn them or not?

Natures Comfort / Changing water
« on: May 12, 2014, 08:47:50 PM »
I want to change water in my boiler but should I drain it and leave empty till fall, wait till fall, or drain and fill now?

Natures Comfort / What's causing the noise
« on: February 17, 2014, 08:43:44 PM »
What cause the actuator on the draft fan flapper to make a buzzing sound when it is actuated? It works just fine but it's driving me nuts a lot of times you can turn it off and turn it back on in the noise goes away. Any ideas on how to fix it?

Plumbing / Frozen line
« on: January 30, 2014, 08:25:12 PM »
I am looking for an idea on how to fall out the frozen water supply line that is underground?

Fire Wood / my wood cutting helpers and toys
« on: January 22, 2014, 08:34:41 AM »
the spreader works great for hauling wood

General Outdoor Furnace Discussion / water ph level
« on: December 01, 2013, 11:17:08 AM »
What should water ph be in boiler? Natures comfort guy I talked to at the factory didn't have a clue. boiler solutions tested it at 11.8
and says its ok and no action required. Others around here say its way to high and that's what ate out my fitting already. If it is to
high how do you lower it? The paper that came in the test kit I got says below 7 will cause it to be more corrosive?

Plumbing / fitting leaking lok at this
« on: November 28, 2013, 05:02:38 PM »
Inside of the one end is all pitted and the other end looks fine. This is only two years old going on third season. Bad fitting otr something else causing this?

Natures Comfort / ok I have pump problems again any ideas
« on: February 10, 2013, 08:06:17 AM »
This is the third pump in say 8 months of burning cause i don't run it year round. I took this one apart and found chunks of black grit stuck in plastic propeller the smaller pieces were bigger bit they broke on removal. It almost looks like black beauty sand blasting shot.

[attachment deleted by admin for space issues]

Natures Comfort / adding bars
« on: November 27, 2012, 09:10:23 AM »
I seen some talk about adding bars in between the fire brick, my question is will this help hold the ash in for better burn time. I have to empty the ash pan way to often with to much ash chunks big chunks. I almost got 30 gallon container full of as this year burning seasoned oak and cherry.

Natures Comfort / hacked
« on: November 16, 2012, 04:18:55 AM »
Looks like this site has been hacked

Natures Comfort / ash pan
« on: November 04, 2012, 06:31:42 PM »
Ok what am I doing wrong? This is my second season with the nc250 and my ash pan has warped in the back and the paint is burnt of the sides. Now the back isn't really under the opening where the fire burns so why is it getting so hot?

Pages: [1] 2