I am currently in the process of getting my garage hooked up to my owb. The pipe is ran into the garage and I have installed all of the fittings on the stove. However, I am not educated when it comes to thermostats and wiring the blower motor. I am going to build my own setup as far as the HX and blower motor are concerned. But once that is complete I don't know how to wire the blower up correctly.
Below is a picture of the wires that come off of the blower motor. The brown wires go to a capacitor (if I remeber right) but I will have to check tonight when I get home. Then there are the 5 wires that come off of the motor. Obviously as the picture shows, there is a white, blue, black, red and orange wire. I would like to set it up so that I can have a switch box to allow for me to change the blower speed by the flip of a switch(s).
Does anyone know how to wire these 5 wires to my power source or have a diagram that would show how they need to be connected? Also, do I need some sort of relay panel that my thermostat wires will connect to to go from 24v to 120? There was a post on here a while back that showed a similar setup that I would like to have. It had a series of 3 or 4 light switches in a box that depending on their positions, would change the fan speed from low, medium low, medium, medium high, high etc. I found a diagram that I think showes how to do this but my wire colors are different than what is represented in the diagram.
I'm lost, can someone help me out here?
Thanks!
[attachment deleted by admin for space issues]