This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Portage & Main / Re: Burn Time

« on: December 27, 2014, 08:46:56 PM »

I like the kerosene idea. thanks!

2

Portage & Main / Re: shut off the blower when wood is out.....

« on: December 17, 2014, 02:11:15 PM »

Ive just bump up the thread BURN TIME. you will find the info there.

3

Portage & Main / Re: Supply aquastat

« on: December 17, 2014, 02:10:29 PM »

Found it! the title of the thread is BURN TIME

4

Portage & Main / Re: Burn Time

« on: December 17, 2014, 02:09:35 PM »

there it is! I was looking for this post. I am bumping it up for another reader purpose. Thanks for the timer /aquastat idea, exactly what I was looking for!

I myself freqeuntly run the furnace with low temps....I suspect that one of my underground pipe is flooded with groundwater, which does not helkp insulation! I hence plan to install two of these systems.....one to cut as describe the blower when water start cooling (low fire) and another one in my house to cut the heating appliance when the water gets below 80F so I dont start cooling my house

Nic

5

Portage & Main / Re: Supply aquastat

« on: December 17, 2014, 01:45:55 PM »

hi, Ive been looking for an hour on the forum to find a solution on my blower cooling my boiler at night when the fire dies....I saw a lot of reference on a solution provided by Slimjim involving an aquastat and a timer....I see where you are going, I like the idea, I would love to find that post though!!! Cannot find it If you would be knid enought to point me in the right direction many thanks in advance