Welcome, Guest. Please login or register.
Did you miss your activation email?

Username: Password:
Pages: 1 [2]

Author Topic: fitting leaking lok at this  (Read 5486 times)

CRJR

  • Full Member
  • ***
  • Offline Offline
  • Posts: 105
    • View Profile
Re: fitting leaking lok at this
« Reply #15 on: May 13, 2014, 02:59:12 PM »
One of the guys I work with has had to replace 2 elbows in his system in the last 3-4 months because of the exact same type of pitting in his fittings. The dezincification was just a thought.
Logged

CRJR

  • Full Member
  • ***
  • Offline Offline
  • Posts: 105
    • View Profile
Re: fitting leaking lok at this
« Reply #16 on: May 13, 2014, 03:01:02 PM »
I hope someone on here can help
Logged

gainerspot

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 57
  • OWF Brand: P&M
  • OWF Model: Ultimizer BL 2840 (soon)
    • View Profile
Re: fitting leaking lok at this
« Reply #17 on: May 19, 2014, 08:05:35 PM »
When I do my install I was going to avoid using 90 and use PEX Bend Supports.  You just put your pex pipe in it and it curves the 90.

 http://www.amazon.com/SharkBite-23051-Supports-Polymer-4-Inch/dp/B007AGKHIW/ref=sr_1_3?ie=UTF8&qid=1400551226&sr=8-3&keywords=PEX+Bend+Supports

I would also read up selecting the correct circulators and make sure that you have the right pump for your application.  Here is a great link.

 http://www.taco-hvac.com/uploads/FileLibrary/SelectingCirculators.pdf
Logged

Sprinter

  • Do it right the first time, its cheaper In the long run
  • Global Moderator
  • Sr. Member
  • *****
  • Offline Offline
  • Posts: 474
  • OWF Brand: Indoor Boiler
  • OWF Model: Menominee
  • In the long run
    • View Profile
Re: fitting leaking lok at this
« Reply #18 on: May 19, 2014, 08:42:19 PM »
That is good practice, we only use 90's when absolute necessary
Logged
Michigan Thumber
Pages: 1 [2]
« previous next »