So I've run the processor for a total of three days, yesterday still couldn't get a full day in, lost the automatic oiling function on the processor, so set it on manual for the bar, lost that as well after a while, so headed up to the shop and grabbed a 12 volt tester, ended up replacing the only piece of 3 wire cord that I didn't replace before, then ended up just chucking the toggle switch as well as it was getting flaky at best. Did get another three full truck loads yesterday though, 16 foot bed, 8 foot wide, 14 inch high contractors sides, had it heaping full, went back with the Ranger to pick some pieces up that fell off.
Anyways, bring the truck up, dump it on the slab, then use the other loader to shove it up in a pile. Did the math and have close to 18 cords in the pile. How much do you think is lost from spaces between the pieces? I know I won't have 18 cords when it's stacked, but I wonder how much less?