Welcome, Guest. Please login or register.
Did you miss your activation email?

Username: Password:

Author Topic: PM - Modern Hydronics Done Right  (Read 1241 times)

NaturallyAspirated

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 443
  • OWF Brand: Central Boiler
  • OWF Model: M250
  • Golfing, snowmobiling fool!
    • View Profile
    • http://www.nealmastel.com
PM - Modern Hydronics Done Right
« on: December 11, 2018, 01:14:00 PM »

Logged
Miss Farad was pretty and sensual, and charged to a reckless potential; but a rascal named Ohm conducted her home - Her decline was, alas, exponential
Send me your bitcoins!  1GEsGKzP5xK9e45YDjmRzGYpnhwT3oNbvj

1madtrapper

  • Newbie
  • *
  • Offline Offline
  • Posts: 2
  • OWF Brand: Woodmaster
  • OWF Model: 5500
    • View Profile
Re: PM - Modern Hydronics Done Right
« Reply #1 on: February 02, 2019, 09:05:07 PM »

 Great thread I am new also hooked my boiler right up to the manifold turned the boiler to 135 and it worked great but learned from experienced guys to put mixing valve in. Running my house at 105 in and its coming out at 87-90 depending on the temps it has been -40 for the last wk.  I run three speed pumps on the inside to the manifold so you can speed them up or slow them down to change the delta and help fine tune. Still tweaking mine but finding the room temp seems to be about 5 degrees lower then the floor temp.
Logged
Woodmaster 5500
Heating 8000+ ft
70$ a cord here for jack pine and birch...